 July 21, 2009 |
 |
Ryan Maifield Sweeps Qualifying and Defends ROAR 1/8 Truggy National Championship
Utilizing his Factory Team RC8T and recently released Reedy 121 VR engine, Ryan Maifield dominated the competition at Leisure Hours Raceway in Joliet, IL at the ROAR 1/8 Truggy Nationals. In qualifying, Maifield lead the field each round by beating the best in the country time after time. Even after securing the top qualifying spot by round three, Maifield chose to run round four to test a chassis adjustment.
Starting from the pole position for the main event, Maifield got off to a good clean start and never looked back. By going over nine minutes between pit stops his RC8T/Reedy 121 VR combination never missed a beat and lapped the field up to second place and set the single fastest lap time. By the conclusion of the 45-minute main event, Maifield had built a 13+ second lead over second place and was the only driver to make 83 laps. |
 |
 |
 |
Team Associated Pitman Gloves
Great for turn marshalling and pitting nitro vehicles. Three sizes to choose from. |
|
 |
LRP BEC Stabilizing Capacitor
This smart BEC Stabilizing Capacitor stabilizes the voltage for your receiver and is especially important when running in racing classes that run on a low level of voltage input, such as 4-cell 1:12 class. |
|
 |
LRP "High Flex" Sensor Wires
LRP releases new extra-flexible high-quality sensor wires for your motor and speed control connections. Offered in four different lengths: 70mm, 100mm, 150mm, 200mm. |
|
|
